This course, developed by the New Jersey Chapter, will provide the engineer, contractor & concrete producer and understanding of the latest in concrete technology & knowledge to make the appropriate decisions in the field, including troubleshooting. In addition, it provides upon successful completion of the course & exams, certification by the New Jersey Chapter that the candidate understands the basics in concrete technology & meets the certification requirements of the NJ DOT & the Port Authority of NY & NJ.

• From the basics of concrete mix designs to developing concrete mixes to produce more workable & job specific mixes.

• Learn the latest about concrete admixtures & when & how to properly use them.

• Mix designs that have been successfully used. How to properly place, finish & cure this concrete.

• How to successfully place concrete in hot & cold weather with good results. Mix designs, batching, curing procedures, & testing to meet these conditions.

• Common concrete construction problems will be discussed. What causes these problems, how to prevent them & corrective action to be taken when they occur.

• The common sense essentials to a successful concrete project such as: pre-construction meeting, ordering concrete, etc.

DATES

November 18,19 and 20

TIMES

November 18 and 19 (8;00AM- 4:00 PM)

November 20 (8:00AM- 3:00PM)

Continental breakfast and lunch will be provided

Please Note

A maximum of 50 students can be accepted. Acceptance will be on a "first paid" basis.  Register as soon as possible to insure a spot. Faced or emailed registrations will only be held for one week without payment. For additional course information contact  Cas Bognacki at 516 780 1372 or email [email protected].